Elite Lighting HV6PL-1X18-E-120 HV6PL 6” Non-Conducting Architectural Polycarbonate Front Downlight

1. LAMP HOLDER - Die-cast aluminum lamp holder effectively provides heat dissipation and ventilation. Unitized optics guarantees proper trim to housing installation. Tool-less installation adjustability from either outside the housing or inside the housing. 2. MOUNTING BRACKET - Constructed from 16-gauge steel and is supplied with C-channels that are adjustable up to 28". Mounting brackets may be adjusted up to 2-¾" vertically from inside the housing. 3. RETAINING SPRINGS - Precision tooled springs secure trim to mounting frame, for effortless and tool-less installation. 4. JUNCTION BOX/BALLAST - UL listed for through-branch circuit wiring and has four ½" KO's, one ¾" KO and four Romex knockouts with pry-out slots and strain clamps. Ballast and Junction Box are accessible from below, no tools required. Ballast supplied is manufactured by Philips Advance, Universal Technologies or Lutron Electronics. 5. MOUNTING FRAME - Die-formed construction for maximum heat dissipation and rust protection. OPTICS 6. REFLECTOR - Self-flanged .050" aluminum reflector with low iridescent finish. Reflector provides 45-degree lamp-to-reflector image cutoff. 7. GROOVE BAFFLE - Self-flanged one-piece aluminum with concentric rings. 8. LENS - Non-conducting polycarbonate trim w/ polycarbonate prismatic lens, frosted lens, clear lens, tempered albalite lens, tempered fresnel lens, tempered prismatic lens, tempered frosted lens, tempered drop opal lens, tempered frost dome lens, tempered designer point lens, and tempered designer cone lens. Fastened with two torsion springs for easy re-lamping. /UL listed for wet or damp location.